Much SNIP<
So I agree, the system needs to be balanced, and we absolutely need a good
enough heat transfer to the air - the final step. I think that my point
was
that
nucleate boiling is mandatory to get a high enough heat transfer from the
very
hot parts of the engine to the fluid, since phase change heat transfer is
about
3 orders of magnitude higher than conduction. Regardless of the size of
the
radiator, if there were no nucleate boiling, the engine would overheat
locally.
Higher k helps on radiator size, and cannot be ignored, but is not a show
stopper if it varies moderately.
I think we are really agreeing about 97% here, with a slight disagreement
on
semantics and "why", both of which are not worth much more effort.
Thanks for the good commentary. Excellent points.
Bill
-----------
Actually we agree 100%. I absolutely agree on the need for nucleate boiling
at the hot spots.
There have been proponents on the list asking about other fluids (oils?) that
had higher boiling points, apparently worrying about boilover. These heat
transfer oils, used for industrial processes requiring high temperatures
DON'T make good coolants for engines. Some numbers:
Water k= 0.392 viscosity = 0.0123 Cp = 1.0 (best)
50/50 WG 0.260 0.0287 0.87 (next best)
glycol 0.135 0.086 0.64
Therminol 0.0753 0.1067 0.52 (Much worse, k= 1/5 that of
water, viscosity = 8.5x water, and heat capacity ~1/2 that of water.
Clearly water is best but needs antifreeze because of low temperature
exposure, so some mix of water/glycol is what we use.
Bill
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org