Subject: Oil temp (was o ring status)
From: Paul
Date: 10/4/2000, 5:49 PM


My experience at Cummins showed that the oxidation rate of
conventional motor
oils really takes off right about at 250F. I would not recommend
steady state
operation at that sump temperature. Also, the viscosity of the oil
will be
reduced with higher temperatures. In the RPI / Deere rotary
engines, bearing
oil film thicknesses got to be critical with oil temperatures
below 250F. The
Mazda bearings might be a bit better, but I wouldn't count on it.
Your call
if the trade off for a smaller cooler is worth the risks.

Jon Lauter
Rotary Power Marine Corporation
www.rotarymarine.com

I assumed one uses synthetic oil. I have never really got a
definitive
answer on why Mazda seems dead set against synthetics. Perhaps it is
the wetting
properties compared to conventional oil. Also as a recall synthetic
oil seems to
run off surfaces after sitting for awhile. Tracy is running
synthetics as I recall.

Paul Lamar


        Synthetics     stay on surfaces longer after shutdown.
        Virg



The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org