Mike Pienaar wrote:
I have just stripped my 1998 turbo motor, the O-rings were not brittle but
the oil seal in the end housing at the rear next to the flywheel was very
brittle and crumbled when I tried to take it out . By upping the specs on
the O-ring and increasing oil temps are we not just shifting the problem to
the next weakest link in the chain?
I had the same orange crud in the water pump that Paul found but the rest of
the block was very clean. The rotor housings are scored and appear useless.
All the seals were stuck in the grooves on the rotors. I have not measured
anything else yet.
The turbo housing was cracked as Paul predicted.
The oil in the sump was very clean and there was no sludge, much cleaner
than I have ever seen in a piston engine.
Mike Pienaar, Swaziland
You have a point there Mike. Was that oil seal red in color? If so I suspect it
is silicone. If it is red (mine is) and it is silicone it is not recommended
for Alphatic and Aromatic Hydrocarbons and synthetic lubricants containing
silicone. This may be the key to why Mazda does not recommend synthetic oil.
Is your rear oil seal leaking Tracy?
In any event a teflon or Kalrez seal with a steel spring will be rated
to 500 degrees F and has excellent resistance to almost all chemicals.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org