Subject: Oil temp (was o ring status)
From: Paul
Date: 10/4/2000, 9:21 AM


Mike Pienaar wrote:

I have just stripped my 1998 turbo motor, the O-rings were not brittle
but
the oil seal in the end housing at the rear next to the flywheel was very
brittle and crumbled when I tried to take it out . By upping the specs on
the O-ring and increasing oil temps are we not just shifting the problem
to
the next weakest link in the chain?

I had the same orange crud in the water pump that Paul found but the rest
of
the block was very clean. The rotor housings are scored and appear
useless.
All the seals were stuck in the grooves on the rotors. I have not
measured
anything else yet.

The turbo housing was cracked as Paul predicted.

The oil in the sump was very clean and there was no sludge, much cleaner
than I have ever seen in a piston engine.

Mike Pienaar, Swaziland

You have a point there Mike. Was that oil seal red in color? If so I
suspect it
is silicone. If it is red (mine is) and it is silicone it is not
recommended
for Alphatic and Aromatic Hydrocarbons and synthetic lubricants containing
silicone. This may be the key to why Mazda does not recommend synthetic
oil.

Is your rear oil seal leaking Tracy?

In any event a teflon or Kalrez  seal with a steel spring will be rated
to 500 degrees F and has excellent resistance to almost all chemicals.

Paul Lamar

Mike Pienaar wrote:

No, the oil seal was black

Regards

Mike

That is a 1998 engine and not a 1989 engine???

It could then have been anything and was probably done in by the heat.
Perhaps it was overheated big time. Check your rotor housing for warpage. 
Why was it removed from the car? Did somebody replace the rear seal with 
something other than 500 degree F silicone some time in its history? Things 
are not computing here. If they used a low cost neoprene replacement seal 
that would be good for only 212 F.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org