Harry Sheldon wrote:
Paul 'n' All,
Does the turbo negate to some extent the effects of
tuned induction and/or exhaust. I'd value observations and advice on
this.
Thanks
Harry S
Apparently not as Mazda saw fit to tune the intake manifold on the
turbo motors as well as the NA motors.
Either that or they saved money by not
redesigning the turbo intake manifolds and just used the old tuned
NA manifolds. As far as power goes you merely up the boost a bit
with an untuned intake manifold. The effective boost (charge density)
at the intake port would then be the same. The HP and thermal load
on the cooling system would also probably be roughly the same.
I could be wrong on the last point as the turbo back pressure might be
slightly higher due to the slightly higher boost required.
What you might get by tuning a turbo intake manifold is lower
fuel burn (lower BSFC).
Almost nobody except Paul Yaw tunes the turbo exhaust manifold on
rotaries. One drawback to tuning the exhaust is a loss of energy to drive
the turbo due to heat radiation from the longer pipes. On the other hand
the TIT (turbine inlet temp) might be lower. It is interesting that the
P47 had the turbo in the aft fuselage.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org