Mike Pienaar wrote:
I have just stripped my 1998 turbo motor, the O-rings were not brittle
but
the oil seal in the end housing at the rear next to the flywheel was
very
brittle and crumbled when I tried to take it out . By upping the specs
on
the O-ring and increasing oil temps are we not just shifting the
problem
to
the next weakest link in the chain?
I had the same orange crud in the water pump that Paul found but the
rest
of
the block was very clean. The rotor housings are scored and appear
useless.
All the seals were stuck in the grooves on the rotors. I have not
measured
anything else yet.
The turbo housing was cracked as Paul predicted.
The oil in the sump was very clean and there was no sludge, much
cleaner
than I have ever seen in a piston engine.
Mike Pienaar, Swaziland
You have a point there Mike. Was that oil seal red in color? If so I
suspect it
is silicone. If it is red (mine is) and it is silicone it is not
recommended
for Alphatic and Aromatic Hydrocarbons and synthetic lubricants
containing
silicone. This may be the key to why Mazda does not recommend synthetic
oil.
Is your rear oil seal leaking Tracy?
In any event a teflon or Kalrez seal with a steel spring will be rated
to 500 degrees F and has excellent resistance to almost all chemicals.
Paul Lamar
Mike Pienaar wrote:
No, the oil seal was black
Regards
Mike
That is a 1998 engine and not a 1989 engine???
It could then have been anything and was probably done in by the heat.
Perhaps it was overheated big time. Check your rotor housing for warpage.
Why was it removed from the car? Did somebody replace the rear seal with
something other than 500 degree F silicone some time in its history? Things
are not computing here. If they used a low cost neoprene replacement seal
that would be good for only 212 F.
Paul Lamar
Mike Pienaar wrote:
Paul
I don't know where the motor comes from, bought it as a used import from
Japan. It does not appear as if it has ever been worked on (no marks on
bolts that I can see etc). Also although the seal was brittle no sign of oil
leaks.
Will check the housings for warpage.
Thanks
Mike
You have aroused my curiosity Mike. Anybody know what color new rear
main seals are?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org