Subject: Car engine died a slow death
From: Paul
Date: 10/7/2000, 5:34 AM

Perry Mick wrote:

The engine in my '86 RX-7 NA finally died and had to be replaced
at 209,000 miles.

I left it idling one afternoon for about 5-10 minutes with the air
conditioner on while waiting for someone to fly into the airport.
When he arrived, I noticed coolant dripping under the car, the
overflow bottle was overflowing.  The coolant temp was high but
not redline.  I shut the engine off and gave the guy a tour of
my plane.  About an hour later when the guy left I hopped in my
car and drove off, forgetting about the coolant incident.  About
ten miles down the road I happened to glance down and saw the
coolant temp nearly pegged.  Pulled over, let it cool down, and
topped off the coolant.

Over the next few weeks it degraded fairly fast after that.  It
bacame harder to start, in fact it wouldn't start normally, I had
to trick it with a fuel pump switch.  Crank the starter with no
fuel, then turn on the fuel pump.  It would flood if I didn't do
this.  There was also a small coolant leak that I believe was in
the engine, as I had to top off the coolant before every drive,
or it would overheat.  I was still able to drive it to work this
way (35 miles), as the drive wasn't long enough for it to lose
enough coolant to overheat.  I think this coolant leak was there
before and caused the initial idling incident.

Finally, Friday morning two weeks ago, it flooded so bad I couldn't
get it started and ran the battery down.  I decided it was time
to swap the engine out. I had rebuilt a junkyard engine just for
this purpose several months ago.

The "new" engine is great.  Starts every time, idles good, has more
power.  Gives me some confidence I can overhaul these things.
I bought this car in '96 with 114,000 miles, with the intention of
driving it into the ground, to see what the failure modes were, if
any.  I now have great confidence in the NA engine to not have
catestrophic failures.  It died a slow death, starting at about
175,000 miles I would say, when I started noticing a lack of power.
Flooding during start became more frequent.  Then the coolant incident.
I think this small internal leak was developing before, I seem to
recall having some problems retaining the coolant level before the
idle incident.  Never saw coolant in the oil, so it was probably
leaking in the exhaust.  Probably the infamous o-ring failure that
Ed Anderson had.

My confidence in the turbocharged engine to not have failures is
a little weaker.  I have an '87 Turbo II that died on me one morning
about 6 months ago. I hit it a little hard leaving the airport while
the engine was still cold.  Suddenly there was a big loss of power.
The engine was running very rough, didn't seem to want to run below
3000 RPM.  Fortunately I didn't let it die, or it probably wouldn't
have started again.  I kept the gas peddle down and kept the RPM up
the whole drive home, 25 miles, through the country and town stop
lights, using the clutch alot.  That car got me home, basically
running on one rotor I believe.  But it would never start again after
that.  I've started to pull the engine but haven't completed that task
for lack of time.  I assume an apex seal went.  But it's also an old
car with a lot of miles, supposedly over 80,000 miles on the not-
original engine.

For what it's worth.

--
Perry J. Mick
Mick Duckt N7XR
http://www.ductedfan.com

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org