Just for general information, in tearing apart the Japanese 91 Turbo II,
the side/center housings and rotor housings were in remarkable shape adding
some credence to the engine being a 35K mile engine. The only wear on the
rotor housing was were the sharp point of the triangular part of the three
piece apex seal and pressed against the housing. While I could not measure
the wear which appeared to be very minimal but the area was more burnished
than other parts of the rotor. I believe the burnished area (approx 1/8"
wide) shows the results of the high pressure generated against the housing
from the small area of this part of the seal. I am installing two piece 2MM
apex seals as I am told they are easier on the housing (triangular part
bearing on the housing is much wider reducing the pressure against the
housing) and also give better compression. Also replacing the inner
coolant 'O" ring with one of the Hayes High Performance silicon rings,
street porting the center housing and installing 9.7:1 high compression
rotors I got from Bruce Turrentine.
Ed
Bulent Aliev wrote:
Ed,
glad to hear that the engine turned out to be in good shape. Are you going again
with the "plugs up" installation?
Bulent
You are not trying to push my anger button are you Bulent? :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org