Subject: Engine mount measurements - pusher
From: Paul
Date: 10/10/2000, 10:23 AM


John Slade wrote:
  >
  > Questions for those flying 13B pushers....
  > I'm about ready to build my mount (13B on a Cozy IV with Tracy's
redrive).
  I know that Long and Cozy drivers like to get the prop as far back as
possible.
  Some use 6 or ever 8 inch prop extensions. Tracy says his redrive is
  "equivalent" to a 4 inch extension when compared to a Lyc 360.
  >
  > Firewall to prop flange
  > What is the plans distance?
  > What distance have others used in 13B installations ?
  >
  >
  > Firewall to engine c of g
  > What is the plans distance?
  > What distance have others used in 13B installations ?
  >
  > What prop extension do you use if any?
  > Any other measurements I should be considering?
  >
  > Regards,
  >
  > John Slade, Cozy MKIV #757, progress: http://kgarden.com/cozy
  > West Palm Beach, FL

I can get you numbers for those on my installation, but
not at the moment.  I think Ed Anderson at one time said
the Ross was 14.5 inches from the 13B rear (where the
transmission bolts) to the prop hub.  In my direct drive
I have a two-inch thick adaptor bolted to the flywheel
plus an 8 inch extension, and it is 12 inches from the
13B rear to the prop hub.

--
Perry J. Mick
Duckt N7XR
http://www.ductedfan.com

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org