Paul,
The 1986 starters are on the plug side. Look in the factory manual pg. 7A-4
and pg. 7B-25 (picture of how the transmission bolts to engine). Two bolts go
through the starter then the bellhousing to the engine (the two lower left
side holes in your drawing)
Ed  pebvjs@aol.com.

Your right. I checked the Hayes manul as I don't have the factory
manual. It looks like they use both bolts down in the lower left
of the engine looking at it from the back. That would save two 10 mm bolts
over Tracy's set up. Good. I will draw it up with the starter down there.

Ok here is a revised Rv4 drawing with a smaller rad at less of angle
to reflect Tracy's redrive rather than the Ross with the starter on
the plugs side.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org