Subject: TSIO 550 -E Lean of Peak or rich of peak?
From: Paul
Date: 10/10/2000, 7:42 AM

Mark Steitle wrote:

Paul,
Here's a posting that came through the Lancair builders sig concerning fuel burn for the TSIO-550. I was curious as to how these numbers compare to 20B-REW ? Obviously, the rotary doesn't have to worry about burned exhaust valves. But I would like to hear from someone actually flying a 20b regarding actual "real-world" fuel burn.
Mark

From: Fred Moreno
A recent article by Orin Riddell in the Lancair Mail periodical issued by the factory had a new set of recommendations for operation of the Continental TSIO-550.  I have copied the information from the table and repeat it below:
% Power Fuel Flow Fuel Setting
100% - 350 HP 41-43 gal/hour full rich
75% cruise climb 51; 262 HP 27-28 gal/hour full rich recommended
65% economy cruise 51; 227 HP 20-21 gal/hour 100F rich of peak
55% economy cruise 51; 192 HP 16-17 gal/hour 100F rich of peak
These figures are much higher than initially recommended apparently because experience has shown that the TSIO-550 suffers high wear and premature cylinder removal when operated at lower fuel flows.   I know that with my TurboSkylane RG, operation at lean mixture settings (permitted by "the book" at lower settings) resulted in three burned exhaust valves at about 1000 hours, and this engine operates a lot cooler than the TSIO-550 Continental.
So I think the answer on leaning is: you pay now (rich mixture) or your pay later (top overhauls), but either way, you PAY.   Unfortunately these high performance, turbocharged aircraft engines have high life cycle costs, taking initial cost, fuel cost, and maintenance cost into account.  Alas.
Fred Moreno


Tracy has always maintained the rotary burns the same amount of gas as a 
air cooled aircraft engine because it can safely run 100 degrees LEAN
of peak. NO EXHAUST VALVES!!!!! 16 gallons and hour at 192 HP 55% power is
a BSFC of 0.5! Right in the ball park with a rotary.

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org