Subject: Engine mount measurements - pusher
From: Paul
Date: 10/11/2000, 8:12 AM


The bare rotary engine weight is about 190 pounds. Tracy's PSRU with
everything is about 45 pounds. The starter is about 7 pounds.
Intake manifold will vary. The alternator weight also varies
>from year to year.


On the other hand it is usually hard to pin down the exact weight
of a Lyc because the configuration weights are not standardized
some time they include the carb, starter, mags alternators,
and exhaust manifolds and sometimes one or more of these parts
are missing in the weight calculations.


John Slade wrote:

I'm going to try and get an average. I'm hoping the moment of the fully
configured 13B will be a bit less than that of the Lyc. This way I can set
it a little further back and, maybe, do without a prop extension. Any
thoughts?

Tracy's redrive is a bit overkill in some areas. You might get a pound or
two out with some expensive machining operations :-) The steel oil pan too 
is a bit heavy. Perhaps an aluminum pan would save a pound or two.
You could acid dip the rear endhousing. That sucker is the heaviest part
of the rotary at around 45 pounds.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org