Subject: Starter location for Cosmo 13B, all 20B and all 3rd gen auto tranny models -
From: Paul
Date: 10/15/2000, 2:22 PM


<<  My starter on the 13-B Cosmo is tucked under the spark plugs  and it's a
geared
 > starter. The draw back is that is very unusual mount and incorporates part
of the
 > engine and part of the bell housing. So if something happens to any of
these
 > parts, I'm screwed. For that reason I have to use the bell housing instead
of the
 > flat plate mount.
 > Bulent >>

Tracy and Paul,
That is the same as all the 3rd gen auto tranny models, and the 20B. A flat
plate on the starter bolts to both the rear housing (different casting than
the 5 speed rear housing) and to the auto tranny bellhousing. I think I sent
a picture of this a few months ago to Paul of this arrangement incl. pics of
the starter on the assemblage.
It may be possible to change the flywheel/counterweight to the smaller pre 88
auto ones and use Tracy's present redrive arrangement or might there some
other problem with this?
How would Tracy's redrive be fit into the auto tranny bellhousing? Has this
been discussed before? I can't visualize this or even know if it is feasible.
More information is needed here to know what we/Tracy can do.
I have a 3rd gen automatic tranny bellhousing, and auto tranny starter
assembly (and a 20B to mate it to) so I can offer the starter/bellhousing
(but not the 20B-it is assembled) to Tracy to look at for feasibility-
What do you say? I have an order in for Tracy's redrive right now!

Marc Wiese 20B .....

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org