Al Gietzen wrote:

I'm about to have a mounting bracket made to mount the Delco (or equiv)
ignition coil/igniters that Tracy specifiies for his ECU-2 and the 20B.  The
bracket mounts all 6 coils in a compact package on the top of the engine,
toward the front.  It uses four existing tapped holes that are on the top of
the #1 and #2 rotor housing, to the plug side of center.

If anyone else is interested in this setup, and would like one of these
brackets, let me know in the next couple of days.  Can significantly cut the
cost by have a few made at the same time.  See drawings below.  These will
be machined out of 6061 billet.

Al

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org