Subject: Motor mounts integrated with redrive plate
From: Paul
Date: 10/18/2000, 5:57 PM


This is what I had in mind. It is more or less to scale as
I don't have a redrive plate or starter here at the house.

The view is from the front of the redrive looking back towards the
flywheel.
Starter on right. Same side as the exhaust. Tractor airplane.
This is a preliminary sketch so there will be some minor changes.

Paul Lamar


Ken Gliders wrote:
Paul, this is even a better idea than your initial concept of the two
brackets located on each side of the engine. The starter location by the
exhaust is a better location for me also via rad under the engine. You can
count me in for the change of the plate.

Ken Gillanders

I have it refined a bit more here. I decided to move the motor mounts
even further out to reduce the rubber compression due to torque, improve the 
vibration isolation and to give more room for the muffler or turbo along 
side the engine. If I am going to have to pay over $1000 for an Inconel 
muffler I might as well run the stock 89-92 cast iron exhaust manifold and
turbo and have good power up high to 14,000 feet or so. I am sure Mazda
checked the turbo on Pikes Peak for over speed.

This sketch also shows the mini PT6 type exhaust pipe coming right out of the
side of the cowling up near the front. The short unrestricted exhaust
pipe will give even more boost with the stock turbo.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

kiscool4.gif

kis-mock-up.jpg