Here is the front view showing why it is a good idea to move
the motor mounts outboard to clear the turbo and muffler if used.
Also you can see why a bottom mounted starter would get in the
way of the rad. This rad may look a bit over kill compared
to Chuck Dunlap's 533 cubic inch rad but I want to be real
sure I can cool the turbo motor at what ever boost results
in acceptable rotor housing temp and turbine inlet temp.
Those are the two limits we must stay within in any engine.
BTW Bill this is the short cowl version of the Kis Cruiser.
I used the short cowl because the turbo motor is heavier than
the NA motor by about 35 pounds.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org