Subject: Motor mounts integrated with redrive plate
From: Paul
Date: 10/18/2000, 7:46 PM

victor delta wrote:

Paul:

A quick question from the sidelines, from  the quiet bleachers, but keenly
interested and actively following members of the forum re Mazda automotive
applications to experimental aircraft applications.  Neither a pure engineer or
tinkerer........somewhere in between!
If I understand your intentions correctly......
You will be using a standard 13b, with stock factory turbo ( from what I have
gleamed to date using Tracey's EFI and reduction gear box).  Would very much like
to know what are your expectations regarding max horsepower available to critical
altitude?  For that matter of fact have you calculated a critical altitude with
the stock turbo installation?  Appreciate any comments you would care to make re
it's (stock engine with stock turbo vs. other [aviation or race] turbo systems)
applicablity/reliability and expected efficacy for flights into the very high
teens and mid twenties flight altitudes on continued basis.
Thanks in advance for your comments.
VD

The year to get is the 89-92 2nd gen stock turbo. The 86-88 2nd gen turbo's 
and exhaust manifolds crack so Mazda made some changes to eliminate that 
cracking in 89. Least I think it was 89. BTW the third gen are not suitable.
too much oriented towards small turbines hence good acceleration.

Well aviation or after market turbo's are better if you can get them with 
Inconel wheels. In that case the TIT can probably go from about 1600 F max 
to about 1750 F max safely. The rotor housing temp should stay under 500 to 
600 F in both cases. The stock turbo is water cooled and all the plumbing
for that and oil feed and drain backs is already done for you.

My wild ass guess is somewhere around 220 HP flat rated to 14,000
feet more or less. If you want to go higher than that you need to be
concerned with turbo over speed. That usually means a larger turbine 
and compressor wheel running at lower RPM. We are working on some 
sort of turbine tach to insure the wheel does not over speed and blow 
up. Could ruin your whole day.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org