Subject: 40 HP PRSU preliminary design review
From: Paul
Date: 10/23/2000, 9:15 AM

Wrathall Mark wrote:

I would apprecieate review and suggestions on this draft of my 40HP PRSU.

 This is not to scale, as I haven't found the Bell gear/shaft yet, which
will drive the sizing of bearings etc. Sorry I sectioned the shaft, forgot
my drawing standards. There are two steps in the shaft, at the end of the
taper to positively locate the prop flange and after the  ball to positively
locate it. The Roller inner race has a spacer to the bell gear flange. The
planetary carrier retention is of the splined type similar to the ross and
Tracy's. The damper is of the Motorbike rear wheel rubber block style. The
light blue housing to the right is to be intergral to the forward rotor
housing.

I have had a look at Pauls design in the website, but am not confident of my
ablitly to engineer the  differential bearing location, or the tapered
rollers preload. Isolating thrust in one ball seems easier. Although it
would be nice to use only two bearings, I can see at least one one thrust
bearing being required.

The Points which concern me are:
One - the ball bearing is caprured in thrust, but there is no mechanical
feature to prevent the shaft from backing out under a prop drag load
(windmilling) except the interference fit of the inner race to the shaft.
Two and Four - Dealing with end play on the sun/damper driven shaft.
Three - radial location of the damper driven shaft end.. I have been
thinking a teflon bushing into the e-shaft. The sun takes care of itself
(right ?)
Five - concerns the rubber dampers ablity to survive oil wetting. I could
put an o-ring between the drive and driven.

I would like to go with internal oil galleries as shown. The drain path is
not shown, but I would like to extend in the PRSU casting down, to give a
common oil pan with the enigne.

Mark Wrathall


Looks real good Mark. I think you need a bit of clearance in the back
of the ring gear to cut the teeth. Would make the PSRU a bit longer.
A nylon or teflon button between part one and two should handle
the prop shaft back out problem. In case three a little grease in there 
should handle that as there should be little relative motion between
parts  three and four. 

Tracy and I differ on this point but the planet
carrier should be free in its slots to center itself in the ring
gear. You might look around for some other material more resistant to 
hot oil than whatever that motor cycle rubber damper is made from.

You may need some precision  needle bearings in the planet pinions.
Also you might think of a stabilizing bulkhead on the front side of the
planet pinions tied to the back side with some additional material.

I assume the teeth are straight cut.

This looks like a fun project. Refresh my memory on the type of engine you
are going to use this on. Why only 40 HP?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org