Al Gietzen wrote:
 >
 > I'm about to have a mounting bracket made to mount the Delco (or equiv)
 > ignition coil/igniters that Tracy specifiies for his ECU-2 and the 20B.
The
 > bracket mounts all 6 coils in a compact package on the top of the engine,
 > toward the front.  It uses four existing tapped holes that are on the top
of
 > the #1 and #2 rotor housing, to the plug side of center.
 >
 > If anyone else is interested in this setup, and would like one of these
 > brackets, let me know in the next couple of days.  Can significantly cut
the
 > cost by have a few made at the same time.  See drawings below.  These will
 > be machined out of 6061 billet.
 >
 > Al
  >>

Finn Lassen wrote:

I had one of my coils (stock)  mounted on the engine mount plate until Tracy
pointed out that the cooler you mount them the better (electronics fails a lot
faster when ambient temp goes up). Don't know if that's an issue here, but thought
I mention it.

Finn
 

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org