tparkes:First tparkes:Last wrote:
How is the motor mounted?
The stock Lancair kit bed motormount for the Continental IO-550 is used, as it also
incorporates the nose gear mount. 4130 extensions were welded to the four lord mounting
points which are about 5" above the standard bed mount. I'll forward a photo soon.
Also, with the radiator at the back of the firewall, he needs to seal the
engine compartment to make it a pressure chamber.
Very true. None of these photos show the extensive baffling that I'm just now
completing. Conceptually, my installation is patterned after Belted Air Power's (and
others) RV-6 V-6, with the added complication of the turbo, which must be isolated from
the airflowing to the radiator. This is accomplished by SS shrouds around the turbo and
inconel exhaust manifold, combined with aluminum baffling that directs heated air
overboard through side louvers.
There is actually about 3" between the turbo exhaust and the nearest radiator hose. (The
photo angle is a test of your depth perception). A SS baffle will separate the two,
directing airflow toward the exhaust tunnel as well as toward the side louvers. With all
baffling in place, the turbo is hardly visible.
The redrive bell-housing is not from a Subaru. It is the bell-housing used by Ross Aero
to mount their redrive to a Subaru. And, yes, that is a seat for an intake manifold
pop-off valve you see near the starter, although it is now rotated 90 degrees to clear
the left intake airflow.
The throttle body is by TWM of Goleta, CA, as is the associated secondary fuel rail and
fuel pressure regulator. The EI system (including TPS) is by MicroTech, and is the same
system used by Chuck Harbert on his 20b powered Velocity.
One of my objectives has been creation of a "stealth" Rotary installation, with minimal
changes to the aircraft profile. Unfortunately, the high turbo position came within a
quarter inch of the fiberglass cowling. This will require either a streamlined hump on
the top left side of the cowl, or a small supplemental cooling air inlet at the same
location. Left side exhaust locations were rejected for another good reason: the only
door opening usable for ground ventilation is on the left side.
More photos later.
Tom Parkes
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org