Subject: Tom Parkes turbo 3 rotor Lancair ES
From: Paul
Date: 10/23/2000, 9:59 AM


tparkes:First tparkes:Last wrote:

How is the motor mounted?
The stock Lancair kit bed motormount for the Continental IO-550 is used, >as it also
incorporates the nose gear mount.  4130 extensions were welded to the >four lord mounting
points which are about 5" above the standard bed mount.  I'll forward a >photo soon.


Also, with the radiator at the back of the firewall, he needs to seal the
engine compartment to make it a pressure chamber.
Very true.  None of these photos show the extensive baffling that I'm just now
completing.  Conceptually, my installation is patterned after Belted Air >Power's (and
others) RV-6 V-6, with the added complication of the turbo, which  must >be isolated from
the airflowing to the radiator.  This is accomplished by SS shrouds >around the turbo and
inconel exhaust manifold, combined with aluminum baffling that directs >heated air
overboard through side louvers.
There is actually about 3" between the turbo exhaust and the nearest >radiator hose.  (The
photo angle is a test of your depth perception).  A SS baffle will >separate the two,
directing airflow toward the exhaust tunnel as well as toward the side >louvers.  With all
baffling in place, the turbo is hardly visible.
The redrive bell-housing is not from a Subaru.  It is the bell-housing >used by Ross Aero
to mount their redrive to a Subaru.  And, yes, that is a seat for an >intake manifold
pop-off valve you see near the starter, although it is now rotated 90 >degrees to clear
the left intake airflow.
The throttle body is by TWM of Goleta, CA, as is the associated secondary >fuel rail and
fuel pressure regulator.  The EI system (including TPS) is by MicroTech, >and is the same
system used by Chuck Harbert on his 20b powered Velocity.
One of my objectives has been creation of a "stealth" Rotary >installation, with minimal
changes to the aircraft profile.  Unfortunately, the high turbo position >came within a
quarter inch of the fiberglass cowling.  This will require either a >streamlined hump on
the top left side of the cowl, or a small supplemental cooling air inlet >at the same
location.  Left side exhaust locations were rejected for another good >reason:  the only
door opening usable for ground ventilation is on the left side.
More photos later.
Tom Parkes

Mark Steitle wrote:

         Reply to:   RE: Tom Parkes turbo 3 rotor Lancair ES
Tom,
Great looking installation!  Gives me a standard to shoot for.  My project is a 20b/Super ES (started 7/00, <10% completed).  I am interested in your engine mount adapters.  Do you have any drawings that you would be willing to share?  Did you enlarge the oil pan?  Retain the 20b water pump/housing?  Radiator dimensions?
Interested in the details,
Mark

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org