Subject: 40 HP PRSU preliminary design review
From: Paul
Date: 10/24/2000, 7:30 AM


Snip> Paul Wrote..I think you need a bit of clearance in the back
of the ring gear to cut the teeth. Would make the PSRU a bit longer.
A nylon or teflon button between part one and two should handle
the prop shaft back out problem. In case three a little grease in there
should handle that as there should be little relative motion between
parts  three and four.

Tracy and I differ on this point but the planet
carrier should be free in its slots to center itself in the ring
gear. You might look around for some other material more resistant to
hot oil than whatever that motor cycle rubber damper is made from.

You may need some precision  needle bearings in the planet pinions.
Also you might think of a stabilizing bulkhead on the front side of the
planet pinions tied to the back side with some additional material.

I assume the teeth are straight cut.

This looks like a fun project. Refresh my memory on the type of engine you
are going to use this on. Why only 40 HP?
Paul

Wrathall Mark wrote:

Thanks for the feed back Paul.

Actually there is no engine...yet. I have come to the conclusion that the
only plane I can offord to operate in Austria is a Hummel bird. I am too big
and heavy to fit in it though, so I am designing my own. I'm certainly not
going flying behind half of Hitlers revenge's engine, so I would like to put
in a small rotary. There is now only one small rotary on the market, the Mid
west, and it costs a fortune.

So before I can make a plane, I need to make an engine. Actually this works
quite well, as I don't have a garage to start building anything anyway, and
the mental exercise keeps the grey matter warm. The engine makes a nice
compact project, and I need to con an old school friends father into
machining the parts for me on the NC machines anyway.

You had a good suggestion with the scaled down PP 13b. Someone jump on any
of my bogus logic. Figuring 1/5th the 200hp of the 13b's, you get about
130cc per rotor for a two rotor (lets call it 150cc). If you start to draw
out a 150cc rotor, you end up with a core engine which just about fits in
the slip stream of the SAE 2 prop flange. Trading off the inefficiency of
oil cooling the rotor housing against the savings of only having one fluid
system would probably pay off at 40hp, but when I started to draw up the LC
rotor housings with 1/8 flat, 1/8 o-ring groove,  another 1/8 flat before
the coolant jacket, and the same on the outside, you don't end up with much
cooling. Maybe aircooling would be better, and lighter. I am figuring on
hogging this out of steel. If this all doesn't work, I stll get the
education.

I would hope to find a straight cut planetary set in some small automatic
transmission with the ring gear and shaft integral and usable. I didn't draw
any detail in the planet carrier, as I would hope this could come from the
auto transmission, with maybe a just replacement for the rear bulkhead. You
suggested the Jatco transmission as being a scaled C6 design. Do you know if
it has straight cut gears? A shaft with an integral ring gear? Unfortunatly
automatics aren't common in Europe.

Mark Wrathall

Unfortunately the Jatco had helical gears just like the C6. There are plenty
of off the shelf spur gears you could use. Boston Gear comes to mind. Quincy Mass.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org