Subject: Paul - O Rings
From: Paul
Date: 10/25/2000, 9:00 AM

Ed Anderson wrote:

Paul,
    Do you recall the dash number or part number for the Teflon O rings from
McMaster Carr for the inner coolant seals (or their dimensions).

Thanks

Ed Anderson

No I don't Ed. The ones I bought were from an expensive source and
they did not use the standard o-ring numbering system. 

You need the equivalent diameter. The water slot is two half circles top & bottom 
connected by short straight sections. Measure the diameter down near the 
lateral center line and then measure the distance from top to bottom. 
This will give you the ability to calculate the ID and OD. Check on 
page 2861 of the 105 McMaster Carr catalog for a AS568A numbering system 
chart. Let us say for the moment it is nine inches in diameter.

O-ring diameters go up in 1/8 inch increments so a 9 inch ID
would be a AS568A X72 part number. The last two digits are the ID in 
1/8 inch increments because 9 times 8 is 72. The first digit (X) we will
discuss below. 

Actually a little oversize on the ID would not hurt as you could cut 
the water O-ring to shorten it and seal the joint with RTV near the 
cool side of the engine such as Lynn has suggested. Sometimes you can 
buy this stuff in continuous stock and cut your own to fit. Don't do 
this with the oil seal o-rings however. 

Now replace the X with a zero for a 1/16 cross section diameter
and you will have it. The new part number would then would be AS568A 072.

The cross section diameter of 1/16 inch is mostly a function of the slot
depth and not the slot width assuming of course the slot is much wider
than 1/16 th of an inch. What you want to shoot for is a cross section
diameter that is about 20% to 30% larger than the slot depth. Not that you have 
that many choices on cross section diameters. It is either 1/16 (a zero) or 
3/32 which is a "one" in the AS568A numbering system first digit. Buy one 
of each and see which one fits the best.

These are made by Greavey Seal Company so contact them and get their
catalog. http://www.creavey.com  Jeff Chrysler at (570) 587 4588    
Creavey shows cross sections that go up in as little as .003 (3 thou) 
increments. I suspect these are customs. They show  .062, .070,
.077 and .080 as well as 3/32 cross sections.

IMHO these high temp Teflon encapsulated silicone O-rings are a major 
improvement in the durability and toughness of the rotary engine.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org