Subject: dimensions of that stock oil cooler
From: Paul
Date: 10/25/2000, 1:10 AM


The Mazda Oil cooler I have fin area is 4.5 High x 2 Thick x 19 long with
the side tanks its length is close to 21" long.

Ed Anderson


Al Gietzen wrote:

Of course there are variables, but as a rough guide; assuming the same heat
rejection density (Btu/hr/cu. in.) as obtained with the Fluidyne and Griffin
units (which are amazingly consistent), you would expect this to give you
about 65,000 btu/hr; 220F oil in, 90F air in.  For 200 hp (75% power on a NA
20B) we need to be able to reject about 140,000 Btu/hr.  Better have at
least two of these on a NA 20B or turbo 13B.

Is a stock 20B oil cooler larger?  Chuck?

Al

I suspect they are somewhat more efficient than the Fluidyne and Griffin.
I think they have turbulators inside the oil passages. A rather expensive
way to make an oil cooler. I have never cut one apart however and I am not
about to cut a good one apart. Perhaps someone can find one in a junkyard
from a crashed car. BTW I think it was Griffen that supplied the coolers
to Chuck Harbert that split and caused the inflight fires.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org