Ed Anderson wrote:
Paul,
Do you recall the dash number or part number for the Teflon O rings
from
McMaster Carr for the inner coolant seals (or their dimensions).
.... BIG SNIP
the slot depth. Not that you have
that many choices on cross section diameters. It is either 1/16 (a zero)
or
3/32 which is a "one" in the AS568A numbering system first digit. Buy one
of each and see which one fits the best.
These are made by Greavey Seal Company so contact them and get their
catalog. http://www.creavey.com Jeff Chrysler at (570) 587 4588
Creavey shows cross sections that go up in as little as .003 (3 thou)
increments. I suspect these are customs. They show .062, .070,
.077 and .080 as well as 3/32 cross sections.
IMHO these high temp Teflon encapsulated silicone O-rings are a major
improvement in the durability and toughness of the rotary engine.
Paul Lamar
Ed Anderson wrote:
Hi Paul,
I took your suggestion and made some measurements for the inner coolant
"O" ring.
The "circle" part of the curve has a radius of 3.95", as best as I could get
from the old geometry trick of find the center of a circle using arcs of a
compass (drawing type). The linear portion was 2..425".
So circumference C = Pi*D = 3.1416*3.95" =24.82" plus each side of linear
portion (2.425 x2 =4.85") and adding the two values I get 29.67" . Taking
that as the circumference of a circular "O" ring gave a diameter of 9.444",
I rounded to 9.50" which with the grove depth being 0.071" (on my used
housings) I selected 1/8" thickness (also matches my recollection of the
thickness of the Hayes rings).
This all led to AS568A-272 part number 9319K289 from McMaster at $11.54
(quite a bit cheaper than Hayes $25 - assuming of course its the correct "O"
ring).
I plan ordering one just to see if it fits.
Thanks again
Ed Anderson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org