Subject: Paul - O Rings
From: Paul
Date: 10/27/2000, 8:43 AM


Ed Anderson wrote:

Hi Paul,

     I took your suggestion and made some measurements for the inner coolant
"O" ring.
The "circle" part of the curve has a radius of 3.95", as best as I could get
from the old geometry trick of find the center of a circle using arcs of a
compass (drawing type).  The linear portion was 2..425".
So circumference C = Pi*D = 3.1416*3.95" =24.82" plus each side of linear
portion (2.425 x2 =4.85") and adding the two values I get 29.67" . Taking
that as the circumference of a circular "O" ring gave a diameter of 9.444",
I rounded to 9.50" which with the grove depth being 0.071" (on my used
housings) I selected 1/8" thickness (also matches my recollection of the
thickness of the Hayes rings).

This all led to AS568A-272 part number 9319K289 from McMaster at $11.54
(quite a bit cheaper than Hayes $25 - assuming of course its the correct "O"
ring).

I plan ordering one just to see if it fits.


Russell Kent wrote:

Well, assuming for the moment your calculated length (29.67") is correct, then the
O ring you ordered is going to be either about 1 1/2" too short (assuming you
ordered AS568A-272 as you said) or about 3/16" too long (assuming you ordered
AS568A-276 as you should have based on your numbers).  Based on Paul's earlier
message, I think you should have ordered AS568A-275, which gives you a diameter of
9.375" and a length of 29.45".  I would think that a minor stretch of the O ring
(0.22") would be easier to manage than a minor shrink (0.18").

All that said, perhaps you could measure the grove length using one of those map
distance meters (I have one around here somewhere; I haven't used it in years).
I'm willing to loan it out if you want to try it.  They are about US$20 at your
local Brookstone or Rand-McNally store.

Russell Kent

Naw, the shrink is easy. You cut it with an exacto knife and glue it together
with red RTV on the cool side of the engine.

BTW Ed we all owe you a lot for being a pioneer on this. Thanks. You know what they
say about pioneers. those are the guys with the arrows sticking out
of them :-)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org