Ed Anderson wrote:
Hi Paul,
I took your suggestion and made some measurements for the inner
coolant
"O" ring.
SNIP
> > > This all led to AS568A-272 part number 9319K289 from McMaster at
$11.54
(quite a bit cheaper than Hayes $25 - assuming of course its the
correct "O"
ring).
I plan ordering one just to see if it fits.
Russell Kent wrote:
Well, assuming for the moment your calculated length (29.67") is
correct, then the
O ring you ordered is going to be either about 1 1/2" too short
(assuming you
ordered AS568A-272 as you said) or about 3/16" too long (assuming you
ordered
AS568A-276 as you should have based on your numbers). Based on Paul's
earlier
message, I think you should have ordered AS568A-275, which gives you a
diameter of
9.375" and a length of 29.45". I would think that a minor stretch of
the O ring
(0.22") would be easier to manage than a minor shrink (0.18").
All that said, perhaps you could measure the grove length using one of
those map
distance meters (I have one around here somewhere; I haven't used it in
years).
I'm willing to loan it out if you want to try it. They are about US$20
at your
local Brookstone or Rand-McNally store.
Russell Kent
Naw, the shrink is easy. You cut it with an exacto knife and glue it
together
with red RTV on the cool side of the engine.
BTW Ed we all owe you a lot for being a pioneer on this. Thanks. You know
what they
say about pioneers. those are the guys with the arrows sticking out
of them :-)
Paul Lamar
Ed Anderson wrote:
Well, Russell, I measured a number of times to try to average out any
errors, and entered the dia of 9.5" and thickness of 1/8" into McMasters
selection criteria and I thought it had spit out AS568A-272, but it was
getting a little late and I did not double check it.
So in responding to your e mail I went and checked again this is what I
got from McMasters
Dash Number 272 9-1/2" Inside Diameter, 9-3/4" Outside Diameter, 1/8"
Wide, Shore A: 70 Durometer
Orange Teflon-Encapsulated Silicone O-Rings
Part Number 9319K289
This item matches all of your specifications.
Click the part number to view pricing information or to add this item to
your order.
The "O" specification menu only gave 91/4, 9 1/2 or 9 3/4 as closest choices
to what I had calculated. I chose 9 1/2" as this would only be approx 2/32"
larger dia than what I had calculated. Good idea about using the map
measuring device. Thanks for the offer to loan it, I'll wait until the one
"O" ring I ordered comes in and then see whether I need to do it again {:>)
Thanks Paul, there are times when I must resemble a porcupine {:>)
Ed Anderson
Matthews NC
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org