Subject: Barry rubber motor mount part numbers
From: Paul
Date: 11/5/2000, 2:15 PM


Forgive me for not paying attention.  Are the Barry rubber mounts on the
firewall meant to replace the rubber mounts normally seen between the mount
and the engine?  The clarifying question; do you then have rigid coupling
between the mount and engine?

Chris Cosman

Yes they are Chris. The mounts in the firewall are instead of the
mounts between motor mount steel tube space frame and engine.
They need not be however. Vance recommends both. The ones in the firewall
being much stiffer than the normal ones between engine and motor mount
space frame. The purpose of those in the firewall is to distribute the 
concentrated loads better into the composite firewall.

Yes the steel tube frame is rigidly connected to the engine when the
only rubber mounts are in the firewall.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Perry-Mick-right_new5.gif