Scott Gettings wrote:

150 HP  from 74 lbs??  Is that right? The 13B bare block without flywheel  weighs 160  lb.

Scott Gettings

Its an all aluminum engine Scott. Well not the rotors and e-shaft. That is less PSRU too
and maybe 8000 RPM. The Mazda 13B is about 1300 cc as I recall. Jeff Spitzer
was project engineer on this engine while he was with Moller.

Paul Lamar

Here is a picture of the engine before it was converted to water cooling by Jeff.
It was based on the single rotor OMC snow mobile engine.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org