Subject: Now I know Where you are at
From: Paul
Date: 11/6/2000, 4:49 PM


Leonard Garceau wrote:

Hi Paul,

I've figured where all the great information I was reading on the rotary
site was coming from.  I e-mailed to get on your e-mail list and their you
were.  Anyway, it's great to have computers.  I never would get my glastar
done without them now that S-H fell on bad times to say the least.

I'm building a glastar.  I now wished I had gone with a rotary but was
talked out of it by nay-sayers who didn't know as much about rotaries as I
did.  Anyway, I have a Nissan Maxima 1996 VQ30 engine ready for a motor
mount.  It looks like a perfect setup for the Questair Venture type mount
you illustrate.  I have great factory attach points on each side of the
engine just aft of the flywheel.  These attach points are about midway
between the Prop flange and the crankshaft.  I'm using a chain drive.

I have a couple of questions if you would consider?  Do you use any other
supports other than > the upper and lower support tubes?

You will need at least one  diagonal tube somewhere to stiffen the mount
in the lateral plane.

Anything between the upper and lower tubes?

Nothing there.

In lieu of the hatsection, would a mount coming from each side of the
engine act the same a >the hatsection under the engine using the engine as
the mount?

Any bracket strong enough will work. Send a sketch.

I really like this design because it's so clean and I understand the
stress analysis which you explain.  It will fit my engine so well because
the factory mount points were exactly where your mounts are recommended.  I
have some basic drawing if you'd want to look at them.

I was going to use 3/4 4130 .049 as the tubing?  With 350 lbs approx.  I
am going run the stress analysis as you pointed out.

Anyway this engine runs great so far. I have it on a test stand running a
haltech computer.  Very smooth and strong.  This is a very small engine for
a v-6.  I hope it works out OK.  I have to much money in it to turn back
now.

Again,

thanks,

Leonard Garceau
1714 N 3rd St
Bismarck, ND  58501

701-748-222-1233

PS  Know of anyone in my area building an airplane with a rotary?  Not to
many people here!

George Lendich wrote:

Leonard,
Just out of curiosity, just what does the V6 weigh (wet) and
on the chain drive, can you give some info on the HP it will
handle. Is it something you have made yourself -or purchased.
George (down under) always looking at cost effective options.


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org