Paul, i finally got a chance to try the o-rings that you sent to me. the
outer water seal fits very nice but the inner one is not long enough. i think
i messed one of these up by trying to stretch it a little. it did stretch
some but when it did it went all at once. it does fit now but i would be
reluctant to use it because the way it stretched i would think that it necked
down some. also i don't know or think i could do it again 3 times and get it
to fit.
i also tried the oil control ring O-ring and was not able to get to go on.
it seems that it fits the metal scraper part OK but i am not sure about it
going on yet. i haven't given up on this one yet though, i may need a tool to
help guide the ring over the metal part of the rotor. i will let you know
further as i find out. tom Kimsey
You only need to have about 10% to 20% greater diameter for them to work.
Sounds like we need some size adjustments. I have some from that set I sent
you so I will measure them and come up with new part numbers when you find
out what works and does not work. Ed Anderson is also experimenting with
these O-rings.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org