Harry Sheldon wrote:

Having just gone through thee excercise of purging old messages it seems

that if

a concensus exists it is for Turbocad (6.5pro ?) so when I get my new

computer

perhaps that's the go.
George Lendich,    ----- I'm interested in the 'weldable' Barry mount

cups. If

you are going that way maybe combine & save on ordering &

postage/shipping costs?

George Lendich wrote:

Hello There Harry,

Barry Mounts - the only way to go as far as I'm concerned.
Hey what a great outcome for homebuilt R&D - I had heard
of people using sway-bar bushings and I had it in the back
of my mind that there had to be a better way than the high
cost method - now we have Barry Mounts.

The only problem is Harry - I'm not ready for them and won't
be for some time so I haven't taken a lot of notice of the weld
on mount or the cost of same - I assume it is as cost effective
as the bushings themselves. Did I see a drawing on the weld
on mount !?  I can't remember!! I've probably got it on disk
somewhere, as I save the good bits. Maybe it is just as easy
to make Harry, if it's just tube and washers !?
Considering the exchange rate of our Pacific Paso (Aust $)
at this point in time
George Lendich <lendich@hypermax.net.au>
PS  Drop me a line (direct) if you have further details on cost etc.

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org