Subject: Freedom Engine, rotary FYI
From: Paul
Date: 11/7/2000, 8:39 AM


George Lendich wrote:

Paul,
150 Hp is more than I need - how do they get it out of a 74 lb package,
is that with turbo or just normal !?
George (down under)

Normally aspirated with aluminum center and end housings.

Well you will also need a 25 to 30 pound 3:1 psru, rads, oil coolers,
starters,
alternators, ect., ect., ect..
Paul Lamar


Wrathall Mark wrote:

I have requested interface drawings from Freedom.
http://www.freedom-motors.com/
Looking at the 126 kb pdf file which has the specs for this engine (under
latest news), it doesn't look like much thought has been given to gearbox
interface. You probably have to pick up the rotor housing bolts. Hopefully
the output shaft has a taper as standard.

This engine is also charge lubricated, so there is no oil system, just
premix. Max speed is given as 6500rpm.

Regards,
Mark Wrathall
B777 Propulsion Engineer
Ph. +43/1 7000 75322
Fax +43/1 7000 575322
Wrathall@laudaair.com
 


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Freedom-Motor-rotor-oval1.gif