Tom, looks like a beautiful install job. I wondered if you planned to use
fire retardant paint on the inside of your cowls?
Chuck H
Thanks for the suggestion. Yes, I have been planning on using the red fire
retardant paint, plus some stainless steel reflective tape in areas of expected
high temperatures. Most of the heat from the turbo and exhaust system will not
come very close to any fiberglass before it is exhausted overboard through the
exhaust tunnels or cowl louvers. The major exception is the area above the
turbo, which originally came within a quarter inch of the fiberglass cowl. There
is now a half inch gap between the turbo and the .049 SS turbo shroud, then
another half inch of cooling airflow between the turbo shroud and the .050 AL
baffle. I will layup a new fiberglass blended airscoop about a quarter inch
above the .050 Al baffle and use the fire retardant paint on its inner surface.
I've wondered whether any other protection might be necessary; for example, the
1/8 inch stainless "blankets" sold by ACS and others. I suppose experimentation
will tell.
Tom Parkes
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org