Tom, looks like a beautiful install job. I wondered if you planned to
use
fire retardant paint on the inside of your cowls?
Chuck H
Thanks for the suggestion. Yes, I have been planning on using the red
fire
retardant paint, plus some stainless steel reflective tape in areas of
expected
high temperatures. Most of the heat from the turbo and exhaust system
will not
come very close to any fiberglass before it is exhausted overboard
through the
exhaust tunnels or cowl louvers. The major exception is the area above
the
turbo, which originally came within a quarter inch of the fiberglass
cowl. There
is now a half inch gap between the turbo and the .049 SS turbo shroud,
then
another half inch of cooling airflow between the turbo shroud and the
.050 AL
baffle. I will layup a new fiberglass blended airscoop about a quarter
inch
above the .050 Al baffle and use the fire retardant paint on its inner
surface.
I've wondered whether any other protection might be necessary; for
example, the
1/8 inch stainless "blankets" sold by ACS and others. I suppose
experimentation
will tell.
Tom Parkes
Jim M wrote:
Have you tried fibre fax from Aircraft Spruce, I have this in my cowl (RV6).
My exhaust is about 1" away in spots from cowl, which runs around 1700 F
leaned, no blistering Nada. You apply spray on contact cement to both
surfaces, fairly cheap.
Jim Mosur
RV6 13B
Brampton, Ontario
Canada
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org