Subject: Leonard Garceau motor mount.
From: Paul
Date: 11/10/2000, 9:01 PM

Leonard sent me some sketches of his proposed motor mount
so it will help us all if we go over it together.

There are a couple of principles to keep in mind when designing a motor
mount. Any hard or mounting point must be located by at least three tubes
joining together with different angles. This includes the points where the 
Barry 2002 rubber motor mount bushings are located. In this top view sketch 
they would be at points A and B. The steel cups that hold the Barry rubber 
bushings are also located at these two points. 

The hard points on the firewall suitable for attaching motor mount tubes
must be near the skin of a composite airplane or at the juncture of
three or more fuselage tubes if the the fuselage is of the steel 
tube type. A hard point on the firewall of a composite fuselage can be beefed
up if necessary with a few extra layers of cloth connecting the back of
the firewall to the fuselage skin.

In Leonard's sketch the X under the engine terminated at the engine with
rubber bushings will not serve to fix points A and B in the horizontal
plane. It will take two other tubes shown in red terminated at the center
of the bottom of the firewall. This assumes a composite airplane. If
a tube type fuselage is used this point must be properly supported 
by three or more fuselage tubes. The X will then not be needed.

I always recommend making a 1/4 scale model of the engine using balsa wood or
pine and then making a 1/4 scale model of the motor mount tubes
using 3/16 square balsa sticks. Use 3/8 plywood to simulate the firewall
on a composite airplane or make a stick model of the fuselage if a tube
type fuselage is used. Welding rod can also be used. A very accurate model 
can be made using little rubber motor mounts  made out of soft
rubber washers. A two inch Barry 2002 would then be a 1/2 inch in diameter
in quarter scale. The 1/2 inch diameter bolt normally holding the Barry could 
then be a #6 or #8 screw.

You can learn a tremendous amount from this model about where the tubes should
go and what is rigid enough and what is not by twisting it using your hands. 
Well worth the time needed to make it. I highly recommend it.

More about Leonard's motor mount to come.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Garceau-top-view.gif