Subject: Leonard Garceau motor mount.
From: Paul
Date: 11/10/2000, 9:32 PM

This is the front view showing the two added tubes to fix points
A and B in the horizontal plane. The bottom diagonals shown will no longer
be needed. The new tubes shown in red should clear the bottom front 
(now the rear) of the oil pan. This is where that 1/4 scale model 
will really pay off. 

These tubes need to be at least 3/4 inch in diameter .049
wall 4130. The lower longitudinal tubes should be 7/8 inch diameter 
.049 wall 4130 tubing. 0.049 thick mild steel gussets should be used 
between all tube junctures.

The 7/8 inch diameter on the longitudinal lower tubes will be safer for 
dropping the plane in on a hard landing. Losing your engine at this point 
can ruin your prop and cowling not to mention your whole day.

More about the motor mount brackets extending out from the engine to come.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Garceau-front-view.gif