Subject: Mystery engine of the month 5
From: Paul
Date: 11/10/2000, 4:42 PM


Lorin Thomason wrote:

That looks like a DynaCam engine.  Hell of an engine from the specs I've
read.  Does anyone on the list run one of these?  Are they as powerful as
they
say?  And most importantly, do they last?  I love the revolver style cylinder
block.  Not too thrilled about the price though.

Lorin


Bill Freeman wrote:

One of the fundamental problems with engines which use a
mechanism other than a std crankshaft and connecting rod for
conversion of reciprocating motion to rotary motion is that many
of them use rolling elements in the design.   This leads to line
contact with very high forces, leading to short life of these
components to the Hertzian contact stress limits.  This is
the cause of failure in all rolling element bearings, spalling,
which is where the cracks be below the surface and eventually
chunks pop off leading to sudden huge increases in friction,
and often seizure.

The DynaCam uses rollers on the bottom of the pistons
driving on a 'wavy' cam, with ---   line contact.  Can't take
heavy loads, I imagine that the slightest hint of detonation
(even small enough not to damage the pistons) would lead
to severe damage to the rollers and cam.

There are numerous other "solutions" to the recip-to-rotary
conversion mechanism, but the crank & conrod espcially with
plain journal bearings has been proven for many decades and
will be hard to beat.  Again this is one of the big advantages
of the rotary, it is mechanically EXTREMELY simple.  Most
'wonder engines' are not.

Piper tested this engine in an airplane and was unimpressed,
perhaps someone on the list knows more about the details
of what turned them off.  They test flew it for a while and
that was the end of it.  If it had been better, we would have
them flying now.

Bill
Long EZ builder & pilot
mechanical engineer

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org