Subject: Taking the Ross apart.
From: Paul
Date: 11/10/2000, 4:56 PM


     > >I would be Jerry as long as you understand the process of taking them
     > >apart is to drill out some press fit pins that Ross uses to hold it
     > >together. At least it looks that way to me. Perhaps Art Luther could enlighten
     > >us on that subject.  There are some unknowns involved in that process. I
     > >would rather have a known junk Ross drive to work with.
     > >
     > >Paul Lamar

     >
     > Paul,  If the disassembly process causes real damage, then I will not
     > do it. However, seems hard to believe that they cannot be torn down.
     > I would like to contact Dave Atkins about his modifications  Could
     > you give me his email or web site?   Jerry

     After thinking about it for awhile and looking at all the pictures and
     drawings I have I think it can be modified with out taking out the prop shaft.
     As I recall Ross tack welded in some pins that hold the prop flange
     to the output shaft. This means  the pins need to be drilled out. The
     good news is the thrust bearing and oiling system can be added with
     out taking the flange off. In other words the prop shaft can stay in the unit.

     Paul Lamar


Art Luther wrote:

Hi everyone, to take a ross drive apart you have to remove the core plugs in the center of the shaft, then you can drive the two pins out, then you can press the flange off, takes about 20 tons, the rest is simple.

 I have just finished redoing one for Greg Rector of Merritt Island, Fl. I made a new housing, and installed two tapered bearings back to back for the thrust, the main reason for this was the fact that this one was used on a pusher, I also machined the inside of the bell housing where the drive bolts to it, then I made a housing for a thrust bearing and bolted it on there, I used a ball thrust bearing with a little preload for the sun gear, looks like it should do a good job, will let you know as soon as I can, I am taking it to him tommorow so he can put it on and try it out.
     Art

Thanks for the report Art.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org