Subject: Tom Parkes Lancair ES Mazda 20b engine installation
From: Paul
Date: 11/10/2000, 4:39 PM


Tom, looks like a beautiful install job. I wondered if you 
planned to use
fire retardant paint on the inside of your cowls?

Chuck H


Thanks for the suggestion.  Yes, I have been planning on using the 
red fire
retardant paint, plus some stainless steel reflective tape in 
areas of expected
high temperatures.  Most of the heat from the turbo and exhaust 
system will not
come very close to any fiberglass before it is exhausted overboard 
through the
exhaust tunnels or cowl louvers.  The major exception is the area 
above the
turbo, which originally came within a quarter inch of the 
fiberglass cowl.  There
is now a half inch gap between the turbo and the .049 SS turbo 
shroud, then
another half inch of cooling airflow between the turbo shroud and 
the .050 AL
baffle.  I will layup a new fiberglass blended airscoop about a 
quarter inch
above the .050 Al baffle and use the fire retardant paint on its 
inner surface.

I've wondered whether any other protection might be necessary; for 
example, the
1/8 inch stainless "blankets" sold by ACS and others.  I suppose 
experimentation
will tell.

Tom Parkes



 Check out Fibrefrax from Wicks,1/16" I think. Virg

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org