marc wrote:
Chuck,
I've wondered about this myself. They DO appear to serve as mounting
bushings for the fuel injectors themselves (looks like the injectors would
not function otherwise unless you made new sockets without deflectors, or
cut the deflectors off the bottom of the things). Do you know if the air
bleed that side feeds the sockets is operational only at idle or does it
also function at high rpm?
I will pose this question to the rotary airplane engine list, where there
are many people building 6000 rpm continuous engines apace! Maybe they know.
Marc
This question is for those who are serious engine builders or
racers. Do the four injector deflectors really do any good
as far as increasing dispersion of the fuel spray for non idle
conditions, or are they there only to improve idle combustion?
It seems that they would interfere with high boost air flow and thus
reduce power somewhat.
Chuck Westbrook - 92R1
Houston RX7 Club
http://www.houston-rx7.net/chuckwestbrook/
In the turbo engines there is an air bleed that works in conjunction
with the deflector bushings to improve atomization and hence BSFC.
The air bleed hole is just above the intermediate housing intake port
and communicates with the pressurized intake manifold I think.
It could get pressuruzed air from the smog pump however. Sort of a
poor man's Orbital Engines type EFI system. How well this works at
high speeds I can not say as Mazda did not mention that in the SAE
paper that talks about this. Namely SAE 841017.
The picture came from an article in the 1983 SAE Journal by Jack Yamaguchi
sent to me by Ed Sadler. BTW Ed if you could OCR that article and send
the pictures as separate JPG's I think that would work better.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org