Todd Carrico wrote:
Todd Carrico:
I would not use Aluminum for the motor mount. Burns easily in case of
fire. An inflight fire is bad enough with out having to deal with
lossing your CG as well.
It will also fatigue eventualy.
I also don't see enough firesleeve in these installations.
tc
There area zillion ways of designing a bracket like this. This one uses
a couple of pieces of 1/2 by 1 inch rectangular 4130 or even 1010
mild steel electric welded tubing welded side by side. A large tube
is welded into it to form the proper support for the rubber bushing.
The fore and aft brace tube is not shown. I forgot to draw it in. :-)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org