Ed Anderson wrote:
As I mentioned somewhile ago, I decided to experiment with the "holely"
muffler. Since there seems to be agreement that the sharp sound of the rotary
is due for the most part to the shock wave of the suddenly open exhaust port, I
wondered if the energy of the shock wave were distributed over time - if that
would help mute the sharpness of the sound. So I drilled holes in two 2" dia
pipes along their 15" length to see if I could not distribute the energy of the
shock wave across those holes rather than the having it all coming out the end
of a pipe at once. Also, the squeezing of the end of the pipe into a "fishtail"
shape is also suppose to help suppress the sound without restricting the exhaust
flow overly much (see attached photos). We will see.
Russell Kent wrote:
I count 41 holes. If they are 0.25" diameter, then that is a total of 2.0 sq. in.
area, which is quite a bit less than the exhaust pipe's 3.1 sq. in. area. If the
holes are 0.33" diameter, then the area is a bit better at 3.5 sq. in. Do you
recall what size drill bit you used?
Of course, neither of the above calculations matter a whit if the "holey" pipes
are open on the fishtail end.
Russell Kent
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org