Subject: New Muffler and Oil Pan
From: Paul
Date: 11/13/2000, 1:24 PM

Ed Anderson wrote:

Hi Paul,
    As I mentioned somewhile ago, I decided to
 experiment with the "holely" muffler.  Since there
seems to be agreement that the sharp sound of the rotary is due for the most
part to the shock wave of the suddenly open exhaust port, I wondered if the
energy of the shock wave were distributed over time -  if that would help
mute
the sharpness of the sound.  So I drilled holes in two 2" dia pipes along
their 15" length to see if
I could not distribute the energy of the shock wave across those holes
rather than the having it all coming out the end of a pipe at once.
Also, the squeezing of the end of the pipe into a "fishtail" shape is also
suppose to help suppress the sound without restricting the exhaust flow
overly much (see attached photos).  We will see.

Here is the new oil pan, which will have header tank, overflow tank and
air/oil separator mounted on a bracket that will use the top row of pan
bolts (different bolts -longer).  This will clean up under the cowling quite
a bit.  Also note the blue fitting on the front end of the oil pan.  That is
for the Ross oil return now, 12 inches lower than where Ross had it
installed on the old oil pan.  That should help eliminate the tendency for
the real seal to leak.

Getting ready to start putting the new engine back on the aircraft this
week.
So hopefully will be in the air before Thanksgiving.

Best Regards

Ed


Here is the muffler. Oil pan next.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Ed-Anderson-mufflers.jpg