Wrathall Mark wrote:
Art wrote>
I have just finished redoing one for Greg Rector of Merritt Island, Fl. I
made a new housing, and installed two tapered bearings back to back for the
thrust, the main reason for this was the fact that this one was used on a
pusher, I also machined the inside of the bell housing where the drive bolts
to it, then I made a housing for a thrust bearing and bolted it on there, I
used a ball thrust bearing with a little preload for the sun gear, looks
like it should do a good job, will let you know as soon as I can, I am
taking it to him tommorow so he can put it on and try it out.
Do you have drawings or photos you could share of this new configuration
Art?
Mark Wrathall
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org