> > Thanks Paul,
Trying to get things under the cowl looking more presentable {:>)
Yes, I did recall your concern about the lubrication of the oil pump
chain
and so did some investigation while I had the engine apart. This is what
I
think I found. It appears (if I am correct about this) that the Mazda
engineers decided not to rely on splash lubrication of the chain and
gears
under the front cover.
... SNIP
Anyhow, examine your front cover and see what conclusion you reach.
Best Regards
Ed Anderson
I took a close look and that hole is for drilling the oil gallery that
supplies oil to the metering pump. Mine has a roll pin in it to prevent
the oil injector pump shaft from moving too far into the engine.
It looks like that is its only function.
I need to get that roll pin out of there so I can more closely examine
the oil injector pump shaft to see what is really going on. I think we
determined quite some time ago that the oil injector pump is gravity fed
with oil at atmospheric pressure. As I recall Jon Lauter mentioned that.
There is another oil hole further out towards the pump that could drain
the
gravity fed oil supply to the injector pump if the engine is run plugs up.
If so it would be a good idea for you to mix 2 cycle oil with your fuel
in case you are not already doing that.
Paul,
Ed Anderson wrote:
Yes, my 86 has a roll pin in it, however, the 91 turbo II does not. I think
you will find that the roll pin does not play any function in restraining
the shaft, at least it did not on my 86. There are two half circle clips on
each side of the gear which hold the gear longitudinally on the shaft while
there is a pin that prevents the gear from rotating on the shaft.
If you remove the top clip you can pull the gear off the top of the shaft
and removing the bottom clip and pin permits you to pull the shaft through
the bottom of the boss. The shaft is necked down where the oil boss feed
and this 1/8" hole are located (the 1/8" hole is across the boss from the
oil feed hole). Then the shaft has two flatten sides below this (near the
bottom) which appear to act as a metering device for the oil..
If indeed there is not any oil pressure to the metering device then of
course their will not be any spray of oil.
However, I thought discussion on the list a while back about the oil
metering device indicated that it was not a pump and relied on oil pressure
from the engine system and that was why some of the schemes for a metering
device using a 2 cycle oil reservoir were difficult to design. As I look at
the drawing for the oil galleys, it shows the oil supply for the metering
device coming right off the galley that also feeds the front main bearing
and that I have my oil pressure sensor (where the oil filter originally was)
which normally reads 50 -80 psi. The drawing sure looks like that oil
galley goes directly to the metering boss. So, Jon may be correct, but it
sure does not appear that way from the drawings..
But, in any case, yes, I do mix 2 cycle oil with my gasoline and have the
metering pump removed and the opening blocked off.
Best Regards
Ed
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org