Subject: Ed Anderson new oil pan.
From: Paul
Date: 11/14/2000, 10:48 PM


Sure looks pretty Ed.

I took a close look and that hole is for drilling the oil gallery that
supplies oil to the metering pump. Mine has a roll pin in it to prevent
the oil injector pump shaft from moving too far into the engine.
It looks like that is its only function.
I need to get that roll pin out of there so I can more closely examine
the oil injector pump shaft to see what is really going on. I think we
determined quite some time ago that the oil injector pump is gravity fed
with oil at atmospheric pressure. As I recall Jon Lauter mentioned that.
There is another oil hole further out towards the pump that could drain the
gravity fed oil supply to the injector pump if the engine is run plugs up.

If so it would be a good idea for you to mix 2 cycle oil with your fuel
in case you are not already doing that.

Paul Lamar


Chuck wrote:

I am looking at my front cover-
Looks like Ed is right- the roll pin does not retain the shaft, as it does
not protrude into the bore. The shaft is retained by a c-clip on the inside
and by a shoulder on the outside. It looks like the roll pin is just in
there as an orifice to squirt oil and leaves some pressure to oil the shaft.
I was thinking of blocking off the metering pump and leaving the shaft out
but now I see the shaft should be left in there. Or also block off the inner
end of the bore to keep the oil squirting on the chain. I think I will just
leave the shaft drive gear off. Looks like the oil gallery feeds three
areas- 1. the oil injector metering pump(not gravity fed) 2. the chain via
roll pin 3. the metering pump drive shaft.

Chuck Dunlap

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org