Subject: Ed Anderson new oil pan.
From: Paul
Date: 11/14/2000, 11:35 PM


I took a close look and that hole is for drilling the oil gallery that
supplies oil to the metering pump. Mine has a roll pin in it to prevent
the oil injector pump shaft from moving too far into the engine.
It looks like that is its only function.
I need to get that roll pin out of there so I can more closely examine
the oil injector pump shaft to see what is really going on. I think we
determined quite some time ago that the oil injector pump is gravity fed
with oil at atmospheric pressure. As I recall Jon Lauter mentioned that.
There is another oil hole further out towards the pump that could drain
the
gravity fed oil supply to the injector pump if the engine is run plugs up.


If so it would be a good idea for you to mix 2 cycle oil with your fuel
in case you are not already doing that.

Paul Lamar

Jean Fouche wrote:

On my '82 12A Rx-7 engine, there is a small oil bleed hole on the front
end of the oil pump housing. It seems that this will allow oil to be
sprayed on the rear of the pump drive gear. Centrifugal force will let
this oil run into the drive chain and effectively lubricate it.

Jean Fouche
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org