Subject: Ed Anderson new oil pan.
From: Paul
Date: 11/14/2000, 3:51 PM

Ed Anderson wrote:

Sure looks pretty Ed.

You might want to think about oiling that oil pump chain.
How was it when you took the engine apart?

Paul Lamar

Thanks Paul,

    Trying to get things under the cowl looking more presentable {:>)

Yes,  I did recall your concern about the lubrication of the oil pump chain
and so did some investigation while I had the engine apart. This is what I
think I found.   It appears (if I am correct about this) that the Mazda
engineers decided not to rely on splash lubrication of the chain and gears
under the front cover.

While I had the front cover off,  I decided to trace the oil bosses in the
front cover and as you may be aware there is a small (1/8" dia) hole in the
edge of the Front side housing (where the front cover mates) and a similar
hole in the front cover.  Its just above the front cover on the side where
the oil "O" ring boss is located. See left most line in attachment of front
cover (Front Cover Oil Galley)

In any case, this boss feeds oil to the boss on the front cover containing
the oil metering shaft.  No surprise so far, but then I found that there is
a 1/8" dia hole (my annotation "Oil Spray Hole") in the metering shaft boss
that points toward the up and inside of the front cover and that oil squirts
out of this hole and splashes everything under the front cover.   Yep!  I
put a small hose into the hole on the edge of the front cover and applied 20
psi air pressure to oil in a container and oil sprayed from the hole on the
metering shaft boss.  Intrigued I took the metering shaft out of the boss
and found that the diameter of the shaft is reduced at the point where it is
running past the hole in the boss presumably to ensure oil flow through the
hole to lubricate gears and chain.

  If you have your front cover off (and don't want to get oil all over the
place) simple blow (or use your air hose) into the oil hole on the edge of
the front cover and feel the airflow out the hole on the metering shaft
boss.

It appears that the engineers may have felt that relying on splash alone to
get oil up to the gears on the main shaft for an engine spinning 7500 rpm
and above was too unreliable and since they already had the oil boss for the
metering shaft that this was a simple and elegant solution to oiling the
gears and chain. My best guess.

So appreciate you bring that up as a potential problem, Paul.  I have been
somewhat concerned since you mentioned it and now feel confident that the
chain (and gears) will get adequate oil.

 The chain, by the way, had no detectable wear, but then it only had 40
hours on it so probably wouldn't have shown much in any case.

 Anyhow, examine your front cover and see what conclusion you reach.

Best Regards

Ed Anderson


I took a close look and that hole is for drilling the oil gallery that 
supplies oil to the metering pump. Mine has a roll pin in it to prevent
the oil injector pump shaft from moving too far into the engine.
It looks like that is its only function.
I need to get that roll pin out of there so I can more closely examine
the oil injector pump shaft to see what is really going on. I think we 
determined quite some time ago that the oil injector pump is gravity fed 
with oil at atmospheric pressure. As I recall Jon Lauter mentioned that. 
There is another oil hole further out towards the pump that could drain the 
gravity fed oil supply to the injector pump if the engine is run plugs up.  

If so it would be a good idea for you to mix 2 cycle oil with your fuel 
in case you are not already doing that.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Ed-Anderson-oilboss.jpg