Russell Kent wrote:
I count 41 holes. If they are 0.25" diameter, then that is a total of
2.0 sq. in.
area, which is quite a bit less than the exhaust pipe's 3.1 sq. in.
area. If the
holes are 0.33" diameter, then the area is a bit better at 3.5 sq. in.
Do you
recall what size drill bit you used?
Of course, neither of the above calculations matter a whit if the
"holey" pipes
are open on the fishtail end.
Russell Kent
Russell,
The holes were drilled with a 5/16" cobalt bullet drill bit. The
fishtail opening is the end of the pipe squeezed down to a 1/2" wide slit it
spreads out to almost 4". Wanted to keep the back pressure to a minimum.
Both the "holes" and the "Fishtail" approach are addressed in a book
"Scientific Design of Exhaust & Intake Systems" by Philip H. Smith and John
C. Morrison. The intention is to distribute the energy of the exhaust
shock wave over a wider time period (than simply blasting out the pipe) and
hopefully lessen the sharp intensity of the sound wave. We will see.
Ed Anderson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org